Press the Up/Down button on the keypad once. On the wireless keypad, enter the new 3-8 digit Pin you entered in the keypad set up mode. Press and release this button and the LED will start flashing. Older Genie openers will have a Learn Code button. (The round LED should turn blue and then go off, then the long LED should flash purple. Press and hold the Program/Set button for about 2 seconds. They could be on the bottom side of the opener motor or behind the lens cover on older model Genie’s. Programming your Genie Garage Door opener to the new Keypad First you will need to locate the program buttons and LED lights on the Genie Garage Door Opener. Your single garage door is now ready for programming. On the keypad enter your new PIN (3-8 numbers long). The keypad is now set for all Genie model garage door openers. Release the program key and allow the lights on the keypad to go out. Press and hold the program key until the LED light changes from green to red. The keypad light should go to a solid lighted condition. On the keypad press 3-5-7 and then press the up/down key. This procedure is for programming a single garage door to the keypad. You will first need to prepare the wireless keypad to work with any Genie Intellicode opener. The following procedures will walk you through the programming process. The Genie Model GK-BX (aka: GKCA-BX, GKCG-BX, GKCT-BX) wireless keypad can be programmed to work with 1-3 different garage doors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |